Invoker: This attribute specifies JMX ObjectName of the JMS entry point service that is used to pass incoming requests to the JMS server. This is not something you would typically change from the jboss.mq:service=Invoker setting unless you change the entry point service.

ConnectionFactoryJNDIRef: The JNDI location that this IL will bind a ConnectionFactory setup to use this IL.

XAConnectionFactoryJNDIRef: The JNDI location that this IL will bind a XAConnectionFactory setup to use this IL.

PingPeriod: How often, in milliseconds, the client should send a ping message to the server to validate that the connection is still valid. If this is set to zero, then no ping message will be sent.

ReadTimeout: The period in milliseconds is passed onto as the SoTimeout value of the UIL2 socket. This allows detection of dead sockets that are not responsive and are not capable of receiving ping messages. Note that this setting should be longer in duration than the PingPeriod setting.

BufferSize: The size in bytes used as the buffer over the basic socket streams. This corresponds to the java.io.BufferedOutputStream buffer size.

ChunkSize: The size in bytes between stream listener notifications. The UIL2 layer uses the org.jboss.util.stream.NotifyingBufferedOutputStream and NotifyingBufferedInputStream implementations that support the notion of a heartbeat that is triggered based on data read/written to the stream. Whenever ChunkSize bytes are read/written to a stream. This allows serves as a ping or keepalive notification when large reads or writes require a duration greater than the PingPeriod.

ServerBindPort: The protocol listening port for this IL. If not specified default is 0, which means that a random port will be chosen.

BindAddress: The specific address this IL listens on. This can be used on a multi-homed host for a java.net.ServerSocket that will only accept connection requests on one of its addresses.

EnableTcpNoDelay: TcpNoDelay causes TCP/IP packets to be sent as soon as the request is flushed. This may improve request response times. Otherwise request packets may be buffered by the operating system to create larger IP packets.

ServerSocketFactory: The javax.net.ServerSocketFactory implementation class name to use to create the service java.net.ServerSocket. If not specified the default factory will be obtained from javax.net.ServerSocketFactory.getDefault().

ClientAddress: The address passed to the client as the address that should be used to connect to the server.

ClientSocketFactory: The javax.net.SocketFactory implementation class name to use on the client. If not specified the default factory will be obtained from javax.net.SocketFactory.getDefault().

SecurityDomain: Specify the security domain name to use with JBoss SSL aware socket factories. This is the JNDI name of the security manager implementation as described for the security-domain element of the jboss.xml and jboss-web.xml descriptors.