Red Hat Docs  >  Red Hat Manuals  >  Archived Red Hat Linux  > 

Next Up Previous Contents Index
SCSI parameters

D.2 SCSI parameters

Hardware Module Parameters
Seagate ST0X seagate.o controller_type=1 base_address=base_addr irq=irq
F. Domain TMC-8xx seagate.o controller_type=2 base_address=base_addr irq=irq
F. Domain TMC-3260 fdomain.o setup_called=1 port_base=base_addr interrupt_level=irq
AHA-2920 fdomain.o setup_called=1 port_base=base_addr interrupt_level=irq
Trantor T128 t128.o t128=base_addr,irq
NCR-5380 Based g_NCR5380.o ncr5380=base_addr,irq,dma_channel
AHA 152x aha152x.o aha152x=base_addr,irq,scsi_id,reconnect,parity
AHA 1542 aha1542.o bases=base_addr
Buslogic BusLogic.o buslogic=base_addr
PAS-16 SCSI pas16.o pas16=base_addr,irq
Zip Parallel Port ppa.o ppa_base=base_addr
Always In2000 in2000.o setup_string="ioport:base_addr noreset nosync:x period:ns disconnect:x debug:x proc:x"

Some examples would be:

Configuration Example
Adaptec AHA1522 at port 330, IRQ 11, SCSI ID 7 aha152x=0x330,11,7
Adaptec AHA1542 at port 330 bases=0x330
Future Domain TMC-800 at CA000, IRQ 10 controller_type=2 base_address=0xca000 irq=10

When a parameter has commas, make sure you do not put a space after a comma.

Next Up Previous Contents Index