This is a quick procedure to install a terminal without going through a Setup procedure for both the terminal and the host computer. It probably will not work right if the terminal happens to have been set up incompatible with the computer. If you don't understand some of it you'll need to consult other parts of this document for more info.
To install a terminal, first look in
terminfo.src to find an entry for it (see
Terminfo and Termcap (detailed)). Figure out what serial port
you'll connect it to and what the tty designation is for that port
(e.g. ttyS1 or tts/1), see
As the root user, edit
/etc/inittab and add a getty command
next to the other getty commands. The format of the getty command
depends on which getty program you use.
agetty (called just
getty in the Debian distribution) is the easiest (no
configuration file). See the "
info" or "
For getty parameters use the terminfo (or termcap) name (such as
vt100) for your terminal. Type in a baud-rate that the terminal
supports. But if you set the baud too high you may need to use
Then physically connect the main serial port of the terminal to the chosen serial port of the computer with a file-transfer (null modem) cable and turn on the terminal. Don't expect most ready-made cables to be wired correctly for hardware flow control. Make sure the baud-rate of the terminal is set the same as you gave to getty and that its "data bits" is 8. Then at the computer console type "init q" to apply the changes you made to the inittab file. You should now see a login prompt at the terminal. If you don't, tap the terminal's return key. If this doesn't work read more of this document and/or see Trouble-Shooting.