[dm-devel] Dell MD3000/multipath - huge numbers of I/O errors on boot
Moger, Babu
Babu.Moger at lsi.com
Tue Sep 29 17:22:37 UTC 2009
Good.. Good.. Thanks for the update...
--Babu Moger
> -----Original Message-----
> From: dm-devel-bounces at redhat.com [mailto:dm-devel-bounces at redhat.com]
> On Behalf Of John Hughes
> Sent: Tuesday, September 29, 2009 11:56 AM
> To: device-mapper development
> Subject: Re: [dm-devel] Dell MD3000/multipath - huge numbers of I/O
> errors on boot
>
> Moger, Babu wrote:
> > This is a know problem.. As far as I know these errors mostly come
> during the boot-up if the scsi rdac handler is not there in the initrd
> image. You might want to try building scsi_dh_rdac into the initrd
> image.
> Yay! that works. Now I get a nice quiet(ish) boot:
>
> [ 0.000000] Initializing cgroup subsys cpuset
> ...
> [ 1.292136] SCSI subsystem initialized
> [ 1.294173] rdac: device handler registered
> ...
> [ 30.781404] scsi3 : ioc0: LSISAS1068 B0, FwRev=000a3300h, Ports=1,
> MaxQ=366, IRQ=38
> [ 30.820324] scsi 3:0:0:0: Direct-Access DELL MD3000
> 0735 PQ: 0 ANSI: 5
> [ 30.843415] scsi 3:0:0:0: rdac: LUN 0 (owned)
> [ 30.843838] sd 3:0:0:0: [sdb] 142323712 512-byte hardware sectors:
> (72.8 GB/67.8 GiB)
> [ 30.844158] sd 3:0:0:0: [sdb] Write Protect is off
> [ 30.844251] sd 3:0:0:0: [sdb] Mode Sense: 77 00 10 08
> [ 30.844929] sd 3:0:0:0: [sdb] Write cache: enabled, read cache:
> enabled, supports DPO and FUA
> [ 30.845678] sd 3:0:0:0: [sdb] 142323712 512-byte hardware sectors:
> (72.8 GB/67.8 GiB)
> [ 30.846020] sd 3:0:0:0: [sdb] Write Protect is off
> [ 30.846114] sd 3:0:0:0: [sdb] Mode Sense: 77 00 10 08
> [ 30.846532] sd 3:0:0:0: [sdb] Write cache: enabled, read cache:
> enabled, supports DPO and FUA
> [ 30.846649] sdb: unknown partition table
> [ 30.857018] sd 3:0:0:0: [sdb] Attached SCSI disk
> [ 30.857114] sd 3:0:0:0: Embedded Enclosure Device
> [ 31.229896] sd 3:0:0:0: Attached scsi generic sg3 type 0
> [ 31.234390] scsi 3:0:0:1: Direct-Access DELL MD3000
> 0735 PQ: 0 ANSI: 5
> [ 31.256709] scsi 3:0:0:1: rdac: LUN 1 (unowned)
> [ 31.257125] sd 3:0:0:1: [sdc] 142323712 512-byte hardware sectors:
> (72.8 GB/67.8 GiB)
> [ 31.257444] sd 3:0:0:1: [sdc] Write Protect is off
> [ 31.257539] sd 3:0:0:1: [sdc] Mode Sense: 77 00 10 08
> [ 31.257909] sd 3:0:0:1: [sdc] Write cache: enabled, read cache:
> enabled, supports DPO and FUA
> [ 31.258338] sd 3:0:0:1: [sdc] 142323712 512-byte hardware sectors:
> (72.8 GB/67.8 GiB)
> [ 31.258651] sd 3:0:0:1: [sdc] Write Protect is off
> [ 31.258744] sd 3:0:0:1: [sdc] Mode Sense: 77 00 10 08
> [ 31.259108] sd 3:0:0:1: [sdc] Write cache: enabled, read cache:
> enabled, supports DPO and FUA
> [ 31.259223] sdc:<2>ldm_validate_partition_table(): Disk read
> failed.
> [ 31.264296] Dev sdc: unable to read RDB block 0
> [ 31.264389] unable to read partition table
> [ 31.264521] sd 3:0:0:1: [sdc] Attached SCSI disk
> [ 31.264614] sd 3:0:0:1: Embedded Enclosure Device
> [ 31.528977] sd 3:0:0:1: Attached scsi generic sg4 type 0
>
>
>
> --
> dm-devel mailing list
> dm-devel at redhat.com
> https://www.redhat.com/mailman/listinfo/dm-devel
More information about the dm-devel
mailing list