[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: mount: error 22 mounting ext3



Nik,

Thanks for your suggestion. I wish it was just a simple jumper
mis-configuration. The new drive is on a separate IDE controller, all by
itself, so there's no problem with the jumper settings. Everything works as
expected when I boot using Windows.

Any other ideas?

-----Original Message-----
From: nicola [mailto:nicola]On Behalf Of Nik
Sent: Thursday, May 01, 2003 3:42 PM
To: Andrew Chen
Cc: Stephen C. Tweedie; ext3 users list
Subject: Re: mount: error 22 mounting ext3


Andrew Chen wrote:

> I am unable to boot my original RH 9 with the RH 7.2 drive installed. If I
> disconnect the  the drive (RH 7.2 w/ ext2), then RH 9 boots up fine.
>
> The RH 7.2 drive used to be the boot drive for another system. Now I just
> want to use it as additional storage in my RH 9 system. Hope this
clarifies
> my system problems.
>

May I suggest that the new drive is incorrectly set as "Master" on the ide
connector?
The original drive should have the jumpers set to "Master", the RH7.2 one on
"slave".







[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]