[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: ide/ext3 errors on two identical machines



-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Jeremy Dolan schrieb:
> kernel: hda: read_intr: status=0x59 { DriveReady SeekComplete
DataRequest Error }
> kernel: hda: read_intr: error=0x40 { UncorrectableError },
LBAsect=54666719, high=3, low=4335071, sector=61720
[...]
>   [from dmesg]
>   Uniform Multi-Platform E-IDE driver Revision: 6.31
>   ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
>   PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086,
DID=24db
>   PCI: Device 00:1f.1 not available because of resource collisions
>   PCI_IDE: (ide_setup_pci_device:) Could not enable device.

most likely hardware problems. were the 2 machines on the same
power-line? maybe lightening caused a voltage peak on the machines?

> up-to-date documentation out there on a standard diagnosis procedure for
> this sort of thing?

as usual: try to get contents to a new disk (oh, maybe it's the
controllers fault, so change the controller then), try to fsck/mount the
image, use your backups :-)

Christian.
- --
BOFH excuse #157:

Incorrect time synchronization
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFA2du9C/PVm5+NVoYRAl4QAKCyz9qWCtct/eBUq4FIxKyoSh9ppgCfTnvC
x269dAWkbXGgNnjiJMD6ou4=
=R+9V
-----END PGP SIGNATURE-----



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]