[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[fedora-arm] Sheevaplug and F12



Hi,

I've got a Sheevaplug and I'm using a 4GB SD card to hold the OS.

I followed the instructions at
http://plugcomputer.org/plugforum/index.php?topic=1041.0 but my boot
sequence halts with the lines:

rtc-mv rtc-mv: setting system clock to 2009-12-31 19:12:06 UTC (1262286726)
Waiting 10sec before mounting root device...
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem) on device 179:1.
Freeing init memory: 116K
Warning: unable to open an initial console.

I've googled that warning message but I'm not finding anything that
makes any sense to me.

Can anyone shed any light on what my problem is and where I can start debugging?

Thanks,

Graeme Hilton

PS My environment and uBoot version are attached below.

Marvell>> printenv
baudrate=115200
loads_echo=0
ipaddr=10.4.50.165
serverip=10.4.50.5
rootpath=/mnt/ARM_FS/
netmask=255.255.255.0
console=a0000
e=ttyS0,115200 mtdparts=nand_mtd:0xc0000 0(uboot)ro,0x1ff00000 0x100000(root)
CASset=min
MALLOC_len=1
ethprime=egiga0
bootargs_end=:::DB88FXX81:eth0:none
image_name=uImage
standalone=fsload 0x2000000 $(image_name);setenv bootargs $(console)
root=/dev/mtdblock0 rw ip=$(ipaddr):$(serverip)$(bootargs_end)
$(mvPhoneConfig); bootm 0x2000000;
ethmtu=1500
mvPhoneConfig=mv_phone_config=dev0:fxs,dev1:fxs
mvNetConfig=mv_net_config=(00:11:88:0f:62:81,0:1:2:3),mtu=1500
usb0Mode=host
yuk_ethaddr=00:00:00:EE:51:81
nandEcc=1bit
netretry=no
rcvrip=169.254.100.100
loadaddr=0x02000000
autoload=no
ethact=egiga0
mtdpartitions=mtdparts=orion_nand:0x400000 0x100000(uImage),0x1fb00000 0x500000(rootfs)
ethaddr=00:62:81:a0:00:00
real_bootcmd=setenv bootargs $(bootargs_console) $(mtdpartitions)
$(bootargs_root); nand read.e 0x00800000 0x00100000 0x00400000; bootm
0x00800000
recover1=setenv mainlineLinux yes; setenv arcNumber 2097; setenv
bootcmd run recover2; saveenv; reset
recover2=run recover3; setenv bootcmd $(real_bootcmd); saveenv; setenv
bootargs $(bootargs_console) $(mtdpartitions); bootm 0x00800000
0x01100000
recover3=run recover4; nand erase clean 0x00100000 0x00400000; nand
write.e 0x00800000 0x00100000 0x00400000
recover4=usb start; fatload usb 0 0x00800000 uImage; fatload usb 0
0x01100000 initrd
arcNumber=2097
filesize=1CAE6D
bootargs_nand=console=ttyS0,11200 rw root=/dev/mtdblock2 rootfstype=jffs2
bootcmd_nand=setenv bootargs $(bootargs_nand); nand read.e 0x800000
0x100000 0x400000; bootm 0x800000
bootargs_sd=console=ttyS0,115200 ro root=/dev/mmcblkp01 rootdelay=1
bootcmd_sd=setenv bootargs $(bootards_sd); mmcinit; ext2load mmc 0
0x800000 /boot/uImage-2.6.30-sheevaplug; bootm 0x800000
bootargs_console=console=ttyS0,115200
bootargs_root=rw root=/dev/mmcblk0p1 rootdelay=10 rootfstype=ext2
bootcmd=setenv bootargs $(bootargs_console) $(bootargs_root); run
bootcmd_mmc; bootm 0x0800000
bootargs=console=ttyS0,115200 rw root=/dev/mmcblk0p1 rootdelay=10
rootfstype=ext2
bootcmd_mmc=mmcinit; ext2load mmc 0 0x800000 /boot/uImage-2.6.30-sheevaplug
stdin=serial
stdout=serial
stderr=serial
nandEnvBase=a0000
mainlineLinux=yes
enaMonExt=no
enaCpuStream=no
enaWrAllo=no
pexMode=RC
disL2Cache=no
setL2CacheWT=yes
disL2Prefetch=yes
enaICPref=yes
enaDCPref=yes
sata_dma_mode=yes
netbsd_en=no
vxworks_en=no
bootdelay=3
disaMvPnp=no
enaAutoRecovery=yes
pcieTune=no

Environment size: 2492/131068 bytes
Marvell>> version

U-Boot 1.1.4 (Sep 14 2009 - 15:36:37) Marvell version: 3.4.19
Marvell>>


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]