[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: eth0 problems



Maciek R. wrote:
On Thu, 2004-12-23 at 14:07 +0000, Paul Howarth wrote:


What's the output of:

# grep eth0 /etc/modprobe.conf
# cat /etc/sysconfig/network-scripts/ifcfg-eth0


ifconfig command output is ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3343 errors:0 dropped:0 overruns:0 frame:0
TX packets:3343 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4174142 (3.9 MiB) TX bytes:4174142 (3.9 MiB)
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

route command output ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
169.254.0.0 * 255.255.0.0 U 0 0 0
lo
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Your eth0 driver is not loaded so it's not surprising that these aren't showing it.


ifcfg-eth0 file output ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
# Please read /usr/share/doc/initscripts-*/sysconfig.txt
# for the documentation of these parameters.
IPV6INIT=no
onBOOT=yes

Try changing "onBOOT" to "ONBOOT".


USERCTL=no
PEERDNS=yes
TYPE=Ethernet
DEVICE=eth0
HWADDR=00:c0:9f:42:33:e6
BOOTPROTO=dhcp
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

I must boot my new kernel to get /etc/modprobe.conf.

Why? /etc/modprobe.conf is a regular file and not part of the kernel itself.


Which kernel driver does your card use?

Paul.


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]