GRUB configuration after installing new kernel

[mailing-lists at dragoneyedesign.net]

----- Original Message ----- 
From: <mailing-lists at dragoneyedesign.net>
To: "Luciano Miguel Ferreira Rocha" <strange at nsk.no-ip.org>
Sent: Saturday, May 08, 2004 6:22 PM
Subject: Re: GRUB configuration after installing new kernel


> hey,
>
> where do I have to press shift + page up/down? In grub? while booting?
>
> ----- Original Message ----- 
> From: "Luciano Miguel Ferreira Rocha" <strange at nsk.no-ip.org>
> To: <mailing-lists at dragoneyedesign.net>
> Sent: Saturday, May 08, 2004 6:08 PM
> Subject: Re: GRUB configuration after installing new kernel
>
>
> > On Sat, May 08, 2004 at 06:02:48PM +0200,
> mailing-lists at dragoneyedesign.net wrote:
> > > erm... I am really new to all this boot stuff, if you tell me how I
will
> do
> > > it
> >
> > Hm... It's not that easy without a running system. :/
> >
> > If you can connect a serial cable to another system, you could change
the
> > console to the serial device (console=ttyS0 in grub).
> >
> > Otherwise, try to go up in the messages (shift+page up/down) and see if
> > any partition is found).
> >
> > Also, make sure you compiled the scsi drivers and support for scsi disks
> > in-kernel, not as modules.
> >
> > Regards,
> > Luciano Rocha
> >
> >
> >
> >
>