FC3 Install Fails:"function probe_partition_for_geom() failed"
Robert L Cochran
cochranb at speakeasy.net
Mon Nov 22 05:05:37 UTC 2004
Perhaps a driver for the Adaptec card isn't loading. You can check the
output of 'lsmod' to see if your driver is there.
Bob
David Liguori wrote:
> I'm trying to install FC3 from a DVD burned from the DVD ISO. The
> check sum and media tested OK. Early in the install I get a box that
> says "Ascertation (heads > 0 ) at disk_dos.c:485 in function
> probe_partition_for_geom() failed", with choices "ignore" and
> "cancel". If I chose "ignore" the installation aborts immediately.
> Chosing "cancel" repeatedly apparently allows it to continue, but soon
> I get the same thing again, and eventually, it quits.
>
> I'm using an Adaptec 29160N SCSI card, a Quantum 36 GB drive on SCSI
> ID 0 and a 36 GB Maxtor drive on SCSI ID 1, upon which I'm trying to
> install FC3. I've tried the no probe and text options and manually
> selecting the Adaptec driver, with essentially the same result. I've
> successfully installed FC1 and FC2 on this same hardware, without this
> problem.
>
> Has anyone seen this, and is there a work-around?
>
> David Liguori
>
More information about the fedora-list
mailing list