Is the HP PSC 1315 not recognized by FC4?

[Vinicius]

Vinicius escreveu:
> Jerry DeLisle escreveu:
> 
>> Vinicius wrote:
>>
>>> Jerry DeLisle escreveu:
>>>
>>>> Vinicius wrote:
>>>>
>>>>> Hello,
>>>>>
>>>>> I have a HP PSC 1315 and the computer OS is FC4 (the kernel is 
>>>>> 2.6.12-1.1387_FC4).
>>>>>
>>>>> The command lspci is not showing the printer, but it did show on 
>>>>> FC3 and the printer was working on FC3.
>>>>>
>>>>> Any ideias, please?
>>>>>
>>>>>
>>>>> TIA,
>>>>>
>>>>> Vinicius.
>>>>>
>>>> Go to this site.
>>>>
>>>> http://hpinkjet.sourceforge.net/
>>>>
>>>> There are details for installation.  I have hplip running on FC4 
>>>> like a charm.  Puts an icon in the accessories menu.  Click on that 
>>>> and you have full control.
>>>>
>>>> Jerry
>>>>
>>>
>>> Thanks.
>>>
>>> Is your SELinux active ("enforcing" and "targeted")?
>>>
>>> I have used hplip since 0.8X to 0.9.2 without problem on FC3.
>>> I have compiled and installed it (version 0.9.3) on FC4, but there 
>>> are several "avc denied" due to SELinux.
>>> Unfortunately, I think it's a hardware or configuration issue. I 
>>> don't know if it is due kudzu or the kernel, or other component.
>>> As I said, the command *lspci* is not showing the printer, 
>>> independent of hplip installation or not.
>>>
>>>
>>> Vinicius.
>>>
>> I do have SELinux enabled and have a few "avc denied" messages but all 
>> is working.  I have a PSC 2175 plugged into USB port.  It shows up 
>> fine with lsusb. I do not know the kind of interface for PSC 1315.  I 
>> would try the hplip mailing list and see if they have any ideas.
>>
>> Jerry
>>
> 
> Thanks again.
> 
> I'm participating of the HPLIP forums but without success to solve the 
> problem there.
> 
> I have reinstalled the FC4 from the zero and the problem continues.
> 
> Have you installed the FC4 from the zero or upgraded from another 
> version of Fedora, please?
> 
> My PSC 1315 uses USB to communicate with the computer.
> 
> What's the outputs of the commands lsusb and lspci, please?
> 
> 
> TIA,
> 
> Vinicius.
> 

Before the tip:
"
# lsusb
Bus 005 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
"

After the tip from Kam Leo:
"
Bus 005 Device 001: ID 0000:0000
*Bus 004 Device 002: ID 03f0:3f11 Hewlett-Packard PSC-1315*
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
"

Now I can install the HPLIP driver.


Thanks,

Vinicius.