3c589 Works w/Knoppix 3.9 & 4.0.2 But Not FC4
Mike McCarty
mike.mccarty at sbcglobal.net
Wed Oct 12 03:34:51 UTC 2005
Cliff Savage wrote:
> HP Pavillion ze4125 laptop.
> On board enet and 3c589 pcmcia both hook to source of DHCP.
>
> I can boot Knoppix 3.9 or 4.0.2 and both ethernet
> ports are recognized - they get an ip addy and I can surf.
> I can unplug one...and then the other...rebooting each time
> and I can surf.
>
> This tells me that the 3c589 pcmcia card is known good.
>
> Knoppix sees the 3c589 as eth0, and the onboard enet as eth1.
> FC4 sees the 3c589 as eth1, and the onboard enet as eth0.
> (exactly reversed)
>
> What is knoppix filching out right that
> FC4 is doing incorrectly?
>
> Unfortunately I cannot take a look @ the pcmcia config
> file 'cause it's knoppix.
>
> I'd be glad to post some incantations, but which ones ?
> I could only post incantations from FC4 which would be incorrect
> I assume....since I can't dig into the knoppix fle system.
>
> Thank you folks!
>
What prevents you from digging into the Knoppix file system?
I've never had a problem.
Of course, you have to be booted up under Knoppix...
Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!
More information about the fedora-list
mailing list