[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: F7: My Palm is not detected



Les wrote:
On Fri, 2007-07-13 at 14:54 -0600, Karl Larsen wrote:
Mikkel L. Ellertson wrote:
Renich Bon Ciric wrote:
On Sun, 2007-07-08 at 09:20 -0500, Chris Mohler wrote:
Copy /usr/share/pilot-link/udev/60-libipsock.rules
into /etc/udev/rules.d
Did this
Do tail -f /var/log/messages and press the sync button on the Palm -
see which device is created.  Point J-pilot to the device (mine was
/dev/ttyUSB0) in preferences.
Did this too. Here's the log. It didn't resolve my problem; still can't
connect using J-Pilot.

<--------------------[ Snip listing ]------------------->

Depending on the model your Palm is, you may need to use
/dev/ttyUSB0 or /dev/ttyUSB1. It doesn't look like
60-libipsock.rules create the pilot symlink. I am not sure if it is
created in another rule in F7. It was in F6, but it pointed to the
wrong port for me...

Mikkel
I have a little Palm Z22 that works fine with Windows but I think it has never worked with Linux. No data to solve a problem. Yesterday I plugged it in and nothing happened. Then I found the tab for Palm devices and clicked that. Went through several windows and then it just died.

Karl

I also have a Z22.  Mine works OK with the installed system over USB.
It didn't work too well over the USB switch, though, so I just used the
one open port and plugged it in there.

I don't remember doing anything special to set it up, just loaded the
software and it ran the setup script and set it up and got it running.
I am still on FC6 though.

Regards,
Les H
Regards,
Les H

Hi Les I have FC6 running here to I will boot into 6 and see how it goes.

Karl


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]