[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: F10 -- How do I start AR5413 interface?



check if exists this file:

/etc/sysconfig/network-scripts/ifcfg-wlan0

if yes.

verify if exists this line on the file:

NM_CONTROLLED=yes


Regards,

---------------------------------------------
iarly Selbir ( Ski0s )



On Thu, Dec 4, 2008 at 9:46 AM, Robert Moskowitz <rgm htt-consult com> wrote:
iarly selbir wrote:
run the command lspci and see if the "atheros" appears on the output


Example, my lspci:

0c:00.0 Ethernet controller: Atheros Communications Inc. AR242x 802.11abg Wireless PCI Express Adapter (rev 01)

It does.
03:04.0 Ethernet controller: Atheros Communications Inc. AR5413 802.11abg NIC (rev 01)
      Subsystem: Atheros Communications Inc. EnGenius EMP-8602 (400mw) or Compex WLM54AG (SuperAG)
      Flags: bus master, medium devsel, latency 168, IRQ 17
      Memory at c2100000 (32-bit, non-prefetchable) [size=64K]
      Capabilities: [44] Power Management version 2
      Kernel driver in use: ath5k_pci
      Kernel modules: ath5k


Now what?  How do I define the interface so I can bring it up? And so NetworkManager will recognize it?



Regards,

---------------------------------------------
iarly Selbir ( Ski0s )




On Wed, Dec 3, 2008 at 8:42 PM, Robert Moskowitz <rgm htt-consult com <mailto:rgm htt-consult com>> wrote:

   When I do an ifconfig I only see eth0 and lo.

   system-config-network only shows eth0

   I know the Atheros card is there...


   --    fedora-list mailing list
   fedora-list redhat com <mailto:fedora-list redhat com>


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]