Xorg.conf modelines? fedora 8
Frank Murphy
frankly3d-fedoracore at utvinternet.com
Sat Feb 23 10:41:24 UTC 2008
Where would I place modelines, what section?
Have a dual-monitor setup, I graphic card (2 connectors)
It's working, but there is some vertical up\down movement, which I'm
guessing is due to the widesreen monitors.
xorg ati-driver being used.
Below is xorg.conf in case info is required.
Frank
--------------------------------------------
# Xorg configuration created by system-config-display (some hand edits)
Section "ServerLayout"
Identifier "Multihead layout"
Screen 0 "Screen0" LeftOf "Screen1"
Screen 1 "Screen1" 0 0
InputDevice "Keyboard0" "CoreKeyboard"
Option "Xinerama" "on"
Option "Clone" "off"
EndSection
Section "InputDevice"
Identifier "Keyboard0"
Driver "kbd"
Option "XkbModel" "pc105"
Option "XkbLayout" "gb"
EndSection
Section "Monitor"
Identifier "Monitor1"
VendorName "LG Electronics"
ModelName "LG L194WT (Analog)"
HorizSync 28.0 - 83.0
VertRefresh 56.0 - 75.0
Option "dpms"
EndSection
Section "Monitor"
Identifier "Monitor1"
VendorName "Dell"
ModelName "Dell E178WFP"
HorizSync 30.0 - 83.0
VertRefresh 50.0 - 77.0
Option "dpms"
EndSection
Section "Device"
Identifier "Videocard0"
Driver "radeon"
EndSection
Section "Device"
Identifier "Videocard1"
Driver "radeon"
VendorName "Videocard Vendor"
BoardName "ATI Technologies Inc RV280 [Radeon 9200 PRO]"
BusID "PCI:1:3:0"
Screen 1
EndSection
Section "Screen"
Identifier "Screen0"
Device "Videocard0"
DefaultDepth 24
SubSection "Display"
Viewport 0 0
Depth 24
EndSubSection
EndSection
Section "Screen"
Identifier "Screen1"
Device "Videocard1"
Monitor "Monitor1"
DefaultDepth 24
SubSection "Display"
Viewport 0 0
Depth 24
Modes "1440x900"
EndSubSection
EndSection
More information about the fedora-list
mailing list