[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

IPV6INIT=no, but does anyway on local network



Greetings;

In /etc/sysconfig/ifcfg-eth0 I have the line as in the subject, but I note 
that bringing up eth0, at a fixed ipv4 address in the 192.168 block, there is 
about a 5 second pause doing it, and ifconfig does report what looks like 
valid ipv6 addresses for both eth0 and lo.

eth0      Link encap:Ethernet  HWaddr 00:1F:C6:62:FC:BB
          inet addr:192.168.71.3  Bcast:192.168.71.255  Mask:255.255.255.0
          inet6 addr: fe80::21f:c6ff:fe62:fcbb/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:52899 errors:0 dropped:0 overruns:0 frame:0
          TX packets:45100 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:34184438 (32.6 MiB)  TX bytes:26737247 (25.4 MiB)
          Interrupt:22 Base address:0xa000

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:6888 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6888 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:16987249 (16.2 MiB)  TX bytes:16987249 (16.2 MiB)


How does one go about disabling that?

-- 
Cheers, Gene
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
"Only a brain-damaged operating system would support task switching and not
make the simple next step of supporting multitasking."
-- George McFry


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]