[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: IPV6INIT=no, but does anyway on local network



Hello,

You are using IPv4 ( If IPv6 disabled )...

Edward.

Gene Heskett wrote:

>Greetings;
>
>In /etc/sysconfig/ifcfg-eth0 I have the line as in the subject, but I note 
>that bringing up eth0, at a fixed ipv4 address in the 192.168 block, there is 
>about a 5 second pause doing it, and ifconfig does report what looks like 
>valid ipv6 addresses for both eth0 and lo.
>
>eth0      Link encap:Ethernet  HWaddr 00:1F:C6:62:FC:BB
>          inet addr:192.168.71.3  Bcast:192.168.71.255  Mask:255.255.255.0
>          inet6 addr: fe80::21f:c6ff:fe62:fcbb/64 Scope:Link
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:52899 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:45100 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:34184438 (32.6 MiB)  TX bytes:26737247 (25.4 MiB)
>          Interrupt:22 Base address:0xa000
>
>lo        Link encap:Local Loopback
>          inet addr:127.0.0.1  Mask:255.0.0.0
>          inet6 addr: ::1/128 Scope:Host
>          UP LOOPBACK RUNNING  MTU:16436  Metric:1
>          RX packets:6888 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:6888 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:0
>          RX bytes:16987249 (16.2 MiB)  TX bytes:16987249 (16.2 MiB)
>
>
>How does one go about disabling that?
>
>  
>


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]