Would like to add module parameters
Bob Gill
gillb4 at telusplanet.net
Wed Nov 24 00:02:32 UTC 2004
Hi. I am using FC3. The firewire in FC3 mounts my firewire drives fine
at boot, but I am having problems with the sbp2 (serial bus protocol 2)
kernel module --it gives me "ieee1394: sbp2: aborting sbp2 command"
about 40 times per hour (and times out for 30 seconds each time). An
official solution is to add the parameter 'serialize_io' when I load the
sbp2 module (with modprobe). This was nice and easy before the days of
hotplug, as I could just add serialize_io to /etc/modules.conf. Things
are not so easy in the land of hotplug. Where
in /etc/hotplug/hotplug.functions can I add the parameter serialize_io
(or can I)? There doesn't seem to be anywhere to add module parameters
(without re-writing the script).
Thanks in advance,
Bob
--
Bob Gill <gillb4 at telusplanet.net>
More information about the fedora-test-list
mailing list