[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Hauppauge PVR 250 in FC3

Thank you.

I will check it out. I will try to build the driver from the tar
ball and see if I have better success.

I was wanting to use VLC or VLS to convert my VHS collection to
MPEGs and then put them on DVDs or VCDs. I have an ATI Radeon 
8500 DV in my XP box, but ATI has microcode on the card that 
detects Macrovision copy protection on VHS tapes and will not 
allow me to record from most of my newer VHS tapes. I could not 
get the Hauppauge card to detect in XP either so it may be a 
bad card, or somehow the ATI card is causing the detection to 

On Mon, 2005-10-01 at 16:04 -0500, Jeffrey W. Stein wrote:
> On Mon, 2005-01-10 at 13:38 -0700, Guy Fraser wrote:
> > I built the ivtv module and loaded it but it doesn't seem to 
> > detect my Hauppauge PVR 250, I don't get any errors with dmesg 
> > either.
> > 
> > Does any have one of these cards working in FC3?
> > 
> > 
> I have a PVR 250 card working with FC3 that I use with MythTV, following
> the directions at:
> <http://wilsonet.com/>
> The ivtv modules for some reason don't load automatically in FC3, so I
> need to use "modprobe". I believe there are some additional remarks at
> the above site on moving this earlier in the start-up process, that I
> have not implemented yet. Perhaps you can glean some hints from the
> above site, or others relating to MythTV.
> Also, I haven't gotten lirc (for the remote control) to work since the
> initial installation; but other than that is seems to work ok.
> I am at work right now, so I can't send you what the dmesg output looks
> like; perhaps later.
> Jeff

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]