[katello-devel] Setting up a Dev Environment

[Bryan Kearney]

On 11/21/2012 08:06 AM, Lukas Zapletal wrote:
> On Wed, Nov 21, 2012 at 07:59:19AM -0500, Bryan Kearney wrote:
>> On 11/21/2012 05:44 AM, Miroslav Suchý wrote:
>>> On 11/20/2012 10:28 PM, Bryan Kearney wrote:
>>>> I get output which is at [2]. Per Brad, I think this means that cpsetup
>>>> needs to support a password?
>>>
>>> You need either:
>>> 1) provide password
>>> 2) su - postgres
>>> 3) modify your pg_hba.conf to allow conect to your user without password
>>> - this is disabled by default for security reasons
>>
>> Should I add (3) as a step to the dev instructions?
>
> https://github.com/lzap/ciauciau/blob/master/steps/499-pg-accept-all.sh

ok... will add.

>
>> Since I was following the docs, does everyone agree I should update
>> the docs with this instead of reset data?
>
> Which wiki page are you referring to? I am gonna add a chapter about
> RPM-only development setup, since Mirek created all required packages
> (except few profiling ones you miss).
>
Go to:

http://www.katello.org/get-involved/

and see step 2 which will take you to:

https://fedorahosted.org/katello/wiki/DevelopmentSetup

These steps are close, but the reset data stuff does not work yet.

-- bk