multiple network interfaces

[Joerg Maier]

Hello List,

i have the fpollowing problem:

I want to do automated install without interaction on machines with 2 
network interfaces. During setup, anaconda asks if eth0 or eth1 should be 
used for installation, even if just one interface is configured in ks.cfg. 
Is there a possibility to assign one network interface as the one for 
installation?

Sample ks.cfg-section
++
network --device eth0 --bootproto dhcp
++

BTW: The two netdevices use the same module, they reside on the same chip.

Thanks in advance

Jörg Maier

--
JS20 Service Team
IBM Deutschland Entwicklung GmbH - Lab Boeblingen
phone: 49-7031-16-4762 (T/L: 120-4762)
mail: jmaier at de.ibm.com
http://www.de.ibm.com/entwicklung/