[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: Kickstart NFS fails to find a DHCP address



Hi,

What is visible on the screen is as follows:-

*modules to inset hid key keybdev usb-storage
* module(s) hid keybdev not found
* inserted /tmp/usb-storage.0
* load module set done
* no firewaire controller found
* probing for floppy devices
* first non-detatched floppy is fd0
* system floppy device is fd0
* in startPcmcia()
* pcmcia probe returned: | PCI bridge probe: not found.
Intel PCIC probe: not found.
Databook TCIC-2 probe : not found.
|
* no pcic controller found
* probing buses
* finished bus probing
* modules to inset natsemi usb-ohci
* module(s) usb-ohci.o found
* inserted /tmp/natsemi.o
* load module set done
* sending dhcp request through device eth0
* pump told us: No DHCP reply received
* no dhcp response received

Regards,

Bernard McAuley
bernard mcauley phyworks-ic com


> -----Original Message-----
> From: kickstart-list-bounces redhat com [mailto:kickstart-list-
> bounces redhat com] On Behalf Of Ryan Golhar
> Sent: 16 June 2004 16:51
> To: 'Discussion list about Kickstart'
> Subject: RE: Kickstart NFS fails to find a DHCP address
> 
> If you press Ctrl-Alt-F2 or F3, you'll get a log console, what does it
> say?
> 
> -----
> Ryan Golhar
> Computational Biologist
> The Informatics Institute at
> The University of Medicine & Dentistry of NJ
> 
> Phone: 973-972-5034
> Fax: 973-972-7412
> Email: golharam umdnj edu
> 
> -----Original Message-----
> From: kickstart-list-bounces redhat com
> [mailto:kickstart-list-bounces redhat com] On Behalf Of Bernard
McAuley
> Sent: Wednesday, June 16, 2004 10:02 AM
> To: kickstart-list redhat com
> Subject: RE: Kickstart NFS fails to find a DHCP address
> 
> 
> I'm afraid that this doesn't appear to have any effect, I still get
the
> same startup error.
> 
> Regards,
> 
> Bernard McAuley
> 
> > -----Original Message-----
> > From: Asim Zuberi [mailto:Asim Zuberi 1993 njit edu]
> > Sent: 16 June 2004 14:41
> > To: 'Bernard McAuley'
> > Subject: RE: Kickstart NFS fails to find a DHCP address
> >
> > try these settings at your boot prompt....
> >
> > ksdevice=eth0 lang=en devfs=nomount ramdisk_size=9216
> > ks=nfs:135.1.45.11:/local/RedHat/ks.cfg nofb console=tty1
> >
> > --Asim;
> >
> >
> >
> >
> > =]  -----Original Message-----
> > =]  From: kickstart-list-bounces redhat com
> > =]  [mailto:kickstart-list-bounces redhat com] On Behalf Of =]
> > Bernard McAuley =]  Sent: Wednesday, June 16, 2004 5:57 AM
> > =]  To: kickstart-list redhat com
> > =]  Subject: Kickstart NFS fails to find a DHCP address
> > =]
> > =]
> > =]  Hi,
> > =]
> > =]  After trawling through the e-mail archives, I've found
> > =]  several users with a similar problem, but I haven't found a
> > =]  'good' solution - so I'm hoping that somebody can help me.
> > =]
> > =]  I have a PC attached via a cisco switch (and yet port fast
> > =]  is enabled!) to a DHCP server, from which I'm trying to
> > =]  kickstart (via NFS but that isn't particularly relevant)
> > =]  using a redhat 8.0 boot disk.  When the boot starts the
> > =]  machine looks for a DHCP address, fails to get one and so
> > =]  the boot stops there. (PUMP returns the messages:  No DHCP reply
> > =]  received)
> > =]
> > =]  However, if I boot into a full linux installation (Red Hat
> > =]  7.2 in this
> > =]  case) and run pump I obtain an IP address without problems.
> > =]
> > =]  Looking at the DHCP server is it responding to the
> > =]  DHCPDISCOVER requrest and offering out an IP addres but the
> > =]  machine refuses to pick up the IP address.
> > =]
> > =]  I've put a hub between the switch and the client and used
> > =]  Ethereal to monitor the traffic to and from the machine and
> > =]  with an installation these are the first 2 transactions that I
> get:-
> > =]
> > =]  Frame 12 (342 bytes on wire, 342 bytes captured)
> > =]  Ethernet II, Src: 00:09:5b:61:38:5a, Dst: ff:ff:ff:ff:ff:ff =]
> > Internet Protocol, Src Addr: 0.0.0.0 (0.0.0.0), Dst Addr: =]
> > 255.255.255.255 (255.255.255.255) User Datagram Protocol, =]  Src
> > Port: bootpc (68), Dst Port: bootps (67) Bootstrap Protocol =]
> > =]  Frame 15 (357 bytes on wire, 357 bytes captured)
> > =]  Ethernet II, Src: 00:02:55:aa:7e:3d, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: physerv1.phyworks-ic.com
> > =]  (192.168.181.200), Dst Addr: 255.255.255.255
> > =]  (255.255.255.255) User Datagram Protocol, Src Port: bootps
> > =]  (67), Dst Port: bootpc (68) Bootstrap Protocol
> > =]
> > =]  Frame 17 (342 bytes on wire, 342 bytes captured)
> > =]  Ethernet II, Src: 00:09:5b:61:38:5a, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: 0.0.0.0 (0.0.0.0), Dst Addr:
> > =]  255.255.255.255 (255.255.255.255) User Datagram Protocol,
> > =]  Src Port: bootpc (68), Dst Port: bootps (67) Bootstrap Protocol
> > =]
> > =]  Frame 18 (357 bytes on wire, 357 bytes captured)
> > =]  Ethernet II, Src: 00:02:55:aa:7e:3d, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: physerv1.phyworks-ic.com
> > =]  (192.168.181.200), Dst Addr: 255.255.255.255
> > =]  (255.255.255.255) User Datagram Protocol, Src Port: bootps
> > =]  (67), Dst Port: bootpc (68) Bootstrap Protocol
> > =]
> > =]  The frames continue for a short while, but the PC never
> > =]  picks up on the returning DHCPOFFER packets (which aren't
> > =]  delayed by a long period).
> > =]
> > =]  Compare this to the transaction whilst using PUMP:-
> > =]
> > =]  Frame 5 (357 bytes on wire, 357 bytes captured)
> > =]  Ethernet II, Src: 00:02:55:aa:7e:3d, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: physerv1.phyworks-ic.com
> > =]  (192.168.181.200), Dst Addr: 255.255.255.255
> > =]  (255.255.255.255) User Datagram Protocol, Src Port: bootps
> > =]  (67), Dst Port: bootpc (68) Bootstrap Protocol
> > =]
> > =]  Frame 6 (590 bytes on wire, 590 bytes captured)
> > =]  Ethernet II, Src: 00:09:5b:61:38:5a, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: 0.0.0.0 (0.0.0.0), Dst Addr:
> > =]  255.255.255.255 (255.255.255.255) User Datagram Protocol,
> > =]  Src Port: bootpc (68), Dst Port: bootps (67) Bootstrap Protocol
> > =]
> > =]  Frame 7 (342 bytes on wire, 342 bytes captured)
> > =]  Ethernet II, Src: 00:02:55:aa:7e:3d, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: physerv1.phyworks-ic.com
> > =]  (192.168.181.200), Dst Addr: 255.255.255.255
> > =]  (255.255.255.255) User Datagram Protocol, Src Port: bootps
> > =]  (67), Dst Port: bootpc (68) Bootstrap Protocol
> > =]
> > =]  Frame 8 (590 bytes on wire, 590 bytes captured)
> > =]  Ethernet II, Src: 00:09:5b:61:38:5a, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: 0.0.0.0 (0.0.0.0), Dst Addr:
> > =]  255.255.255.255 (255.255.255.255) User Datagram Protocol,
> > =]  Src Port: bootpc (68), Dst Port: bootps (67) Bootstrap Protocol
> > =]
> > =]  Frame 9 (342 bytes on wire, 342 bytes captured)
> > =]  Ethernet II, Src: 00:02:55:aa:7e:3d, Dst: ff:ff:ff:ff:ff:ff
> > =]  Internet Protocol, Src Addr: physerv1.phyworks-ic.com
> > =]  (192.168.181.200), Dst Addr: 255.255.255.255
> > =]  (255.255.255.255) User Datagram Protocol, Src Port: bootps
> > =]  (67), Dst Port: bootpc (68) Bootstrap Protocol
> > =]
> > =]  Can anybody suggest whats going on here?  Earlier posts
> > =]  have suggested that the DHCP request is timed out too soon,
> > =]  but the time stamps on the install and the pump run are
> > =]  roughly the same (just under 1 second). I'm digging into
> > =]  the sources now, but I really don't want to be rebuilding
> > =]  anaconda if I can help it!
> > =]
> > =]  Regards,
> > =]
> > =]
> > =]  Bernard McAuley
> > =]
> > =]
> > =]
> > =]
> > =]
> > =]  _______________________________________________
> > =]  Kickstart-list mailing list
> > =]  Kickstart-list redhat com
> > =]  https://www.redhat.com/mailman/listinfo/kickstart-list
> > =]
> 
> 
> 
> _______________________________________________
> Kickstart-list mailing list
> Kickstart-list redhat com
> https://www.redhat.com/mailman/listinfo/kickstart-list
> 
> 
> _______________________________________________
> Kickstart-list mailing list
> Kickstart-list redhat com
> https://www.redhat.com/mailman/listinfo/kickstart-list



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]