Networking & kickstart?

[John Oliver]

I'm using a script in %pre that prompts for IP, hostname, etc.  The
asnwers are dumped out as variables and used to set up the config files
in %post  All works well.

Now, it's being used to install the OS on an HP Proliant that's in a
remote datacenter via iLO, and it takes about an hour to transfer all of
the files over iLO. So I got clever, commented out "cdrom" and added url
--url http://ip.of.my.yum.server/path/to/os/  Then, at the end of %pre,
I added /sbin/ifconfig eth0 $IP netmask $NM up  However... it appears
that kickstart sees the "url" directive and therefore assumes that it
must have networking RIGHT NOW!  It tries DHCP, fails, then runs %pre.
I'm not certain if it ever raises the interface or not, but it complains
"Unable to read package metadat"

Is there a way to do what I want to do... NOT configure eth0 in
kickstart, but the way I'm doing it, raise the interface, and install
from a network source instead of the disc?

-- 
***********************************************************************
* John Oliver                             http://www.john-oliver.net/ *
*                                                                     *
***********************************************************************