[Libvir] libvirt on OS X Leopard 10.5.1
Daniel Veillard
veillard at redhat.com
Tue Jan 22 14:10:07 UTC 2008
On Tue, Jan 22, 2008 at 02:38:27PM +0100, Jim Meyering wrote:
> Daniel Veillard <veillard at redhat.com> wrote:
>
> > On Tue, Jan 22, 2008 at 08:00:34AM -0500, Daniel Veillard wrote:
> >> On Mon, Jan 21, 2008 at 11:39:35PM +0000, Daniel P. Berrange wrote:
> >> > I would point you at the snapshot tar.gz here, but it appears to be not
> >> > updated since September
> >> >
> >> > http://libvirt.org/downloads.html
> >>
> >> ./configure: line 35987: syntax error near unexpected token `libxml-2.0,LIBXML_FOUND=yes'
> >> ./configure: line 35987: ` PKG_CHECK_EXISTS(libxml-2.0,LIBXML_FOUND=yes)'
> >>
> >> libvirt.org is a RHEL4 box, seems the pkgconfig requirements which were
> >> introduced break running autogen.sh , so no Makefile, make dist, and no
> >> snapshot apparently. I will try to investigate but I can't believe we managed
> >> to break detection for something as common as libxml2 *on xmlsoft.org itself*,
> >> the irony ...
> >
> > Upgrading pkg-config on the box this goes further but then gets stuck
> > at:
> >
> > configure: error: conditional "HAVE_SASL" was never defined.
> > Usually this means the macro was only invoked conditionally.
> >
> > trying to autogen with
> > ./autogen.sh --prefix=/usr --without-depends --without-sasl
> >
> > I don't understand the problem, it seems
> > AM_CONDITIONAL(HAVE_SASL, [test "$with_sasl" != "no"])
> > is set outside of any conditional block in configure.in
>
> Right.
> Here's an untested patch:
[...]
> dnl Cyrus SASL
> +have_sasl=0
> AC_ARG_WITH(sasl,
> [ --with-sasl use cyrus SASL for authentication],
> [],
> @@ -402,8 +403,10 @@ if test "$with_sasl" != "no"; then
> CFLAGS="$old_cflags"
> LIBS="$old_libs"
> SASL_LIBS="$SASL_LIBS -lsasl2"
> - AC_DEFINE_UNQUOTED(HAVE_SASL, 1, [whether Cyrus SASL is available for authentication])
> + have_sasl=1
> fi
> +AC_DEFINE_UNQUOTED(HAVE_SASL, $have_sasl,
> + [whether Cyrus SASL is available for authentication])
> AM_CONDITIONAL(HAVE_SASL, [test "$with_sasl" != "no"])
> AC_SUBST(SASL_CFLAGS)
> AC_SUBST(SASL_LIBS)
Thanks Jim, looking at the patch I think I understand the error message
now, but I applied the patch (or rather made the change manually), and
I still get the same:
-----
xmlsoft:~/libvirt -> ./autogen.sh --prefix=/usr --without-depends --without-sasl
[no error reported until ...]
checking whether NLS is requested... yes
checking for GNU gettext in libc... yes
checking whether to use NLS... yes
checking where the gettext function comes from... libc
configure: error: conditional "HAVE_SASL" was never defined.
Usually this means the macro was only invoked conditionally.
xmlsoft:~/libvirt ->
-----
also I'm not sure, shouldn't the AM_CONDITIONAL test check $have_sasl instead
or $with_sasl ?
Daniel
--
Red Hat Virtualization group http://redhat.com/virtualization/
Daniel Veillard | virtualization library http://libvirt.org/
veillard at redhat.com | libxml GNOME XML XSLT toolkit http://xmlsoft.org/
http://veillard.com/ | Rpmfind RPM search engine http://rpmfind.net/
More information about the libvir-list
mailing list