[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[libvirt] Re: [Qemu-devel] [PATCH 1/6] Allow multiple monitor devices (v2)



Hollis Blanchard wrote:
On Wed, 2009-04-08 at 13:34 -0500, Anthony Liguori wrote:
Right now only one monitor device can be enabled at a time.  In order to support
asynchronous notification of events, I would like to introduce a 'wait' command
that waits for an event to occur.  This implies that we need an additional
monitor session to allow commands to still be executed while waiting for an
asynchronous notification.

Was there any consensus reached in this thread? I'm once again looking
for ways to communicate qemu watchdog events to libvirt.

We can do multiple monitors as a debugging tool, but to support events, a proper machine monitor mode is a prerequisite.

The real requirement is that events are obtainable via a single communication channel instead of requiring two separate communication channels. Internal implementation will look at lot like these patches.

The reasoning for requiring a single channel is that coordinating between the two channels is expected to be prohibitively difficult. To have a single channel, we need a machine mode. It cannot be done in a human readable fashion.

I think this summarizes the consensus we reached. I don't agree fully with the above but I'm okay with it. Would you agree Avi?

--
Regards,

Anthony Liguori


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]