[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[libvirt] About the qemu networking



Dear libvirt team,

 

I am testing the qemu with libvit networking, and I have a question.

 

First, I connected the switch and server via Ethernet, the link encapsulation is 802.1q (eth1 is trunk link)

 

When I use sub-interface eth1.12 for vlan12,br12 bridged to eth1.12, and then using tap0 ..tapN, the qemu guest networking works fine.

 

But when I use br1 bridged to eth1 without sub-interface, also use tap0… tapn , it does not work.

 

 

The topology as below:

 

              This works fine                             This doest not work

 

Eth1 (trunk)                   eth1(trunk)

|                                   |

|                            --------------

-----------------                       |         

                   |       |                            br1

               Eth1.12  eth1.13                       |

                  |       |                      _______________

                 br12     br13                   |               |

                  |       |                      |              |

                   |       |                     tap0           tapn

           ---------  ----------

           |      |   |   ...     |

           |      |   |            |

        Tap0 …   tapn  tapn+1    tapm

 

 

 

Is the second solution works ? if works? What should I do to ?

 

Thanks very much, I am look forward to hear from you.

 

Best Regards

 

 

杨树林

技术保障中心 网络工程师

snda

上海盛大网络发展有限公司

上海浦东新区碧波路6901号楼

邮编:201203

电话:021-50504740-896570

传真:021-50504740-895746

Emailyangshulin shandagames com

网址:http://www.snda.com

 


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]