[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [libvirt] [PATCHv2 1/1] Assign spapr-vio address type to ibmvscsi controller

On 05/11/2012 06:41 AM, Eric Blake wrote:
On 05/10/2012 03:37 AM, Daniel P. Berrange wrote:
On Thu, May 10, 2012 at 04:39:48PM +0800, Li Zhang wrote:
For pseries guest, the default controller model is
ibmvscsi controller, this controller only can work
on spapr-vio address.

This patch is to assign spapr-vio address type to
ibmvscsi controller.

Signed-off-by: Li Zhang<zhlcindy linux vnet ibm com>
  src/qemu/qemu_command.c |   14 +++++++++++---
  1 file changed, 11 insertions(+), 3 deletions(-)


Needs a v2; 'make check' failed.  In particular, with:
$ make -C tests check TESTS=qemuxml2argvtest VIR_TEST_DEBUG=1

I see failures like:

148) QEMU XML-2-ARGV usb-redir                                         ...
Offset 457
Expect [bus=pci.0,addr=0x4.0x1]
Actual [reg=0x2000]

149) QEMU XML-2-ARGV usb1-usb2
... libvir: QEMU error : XML error: spapr-vio address 0x2000 already in use

It is very strange.
This patch shouldn't change the address type of usb.
I run the test cases with the latest libvirt of master branch,
it seems there is only one vscsi test cases fails.
No the errors you mentioned.

65) QEMU XML-2-ARGV disk-scsi-vscsi                                   ...
Offset 223
Expect [bus=pci.0,addr=0x3 ... FAILED
Actual [reg=0x2000

148) QEMU XML-2-ARGV usb-redir ... OK 149) QEMU XML-2-ARGV usb1-usb2 ... OK

I think I need to make a little change for vscsi test case.
Can you tell me the libvirt version and Qemu version you are using?


I don't know if the change in output is expected or a regression, so I'd
feel a bit safer if we waited until after 0.9.12 to apply a fixed v2.

Best Regards

IBM LTC, China System&Technology Lab, Beijing

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]