Question: building libvirt into the buildroot. Error *** No rule to make target `keycodemapdb/data/keymaps.csv'

[Daniel P. Berrangé]

On Thu, Mar 26, 2020 at 09:53:06AM +0000, Komarov Egor wrote:
> I'm using command from README
> 
> $ mkdir build && cd build
> $ ../configure --prefix=/usr --sysconfdir=/etc --localstatedir=/var
> $ make
> $ sudo make install

This assumes someone is building from an official released tarball,
if building from git extra steps are required.

I think you're running more than that already, because the build log
you attached shows you've run libtoolize / autoconf / automake as well,
possibly via autoreconf.  This is the bit you need to replace with
autogen.sh

> 
> I don't have anything place where I can see how to build libvitd  exept README from git archive.
> 
> If you put me documentation where I can find your advice:
> 
> " you have not run autogen.sh, and thus are missing initilaization of the
> git submodules."

More details on building from git are here:

https://libvirt.org/compiling.html#building

Regards,
Daniel
-- 
|: https://berrange.com      -o-    https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org         -o-            https://fstop138.berrange.com :|
|: https://entangle-photo.org    -o-    https://www.instagram.com/dberrange :|