[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: mode = forward



Hi Michael,

Which component is complaining that the queue is full, audispd or audisp-remote? audisp-remote is used for remote logging and I'm not sure if this is your case. Can you provide us more information about this?

I took a quick look at the source code of version 1.7.18 of audisp-remote and it actually just supports "immediate" mode. Probably "forward" mode is supported by lately versions.

If audispd is complaining about its queue (instead of audisp-remote), you can try to increase the value of q_depth in the audispd.conf file.

Regards,
Marcelo

On 07/28/2012 10:22 PM, Michael Mather wrote:
I am using Ubuntu 12.04, which uses version 1.7.18 of auditd.

Audispd is complaining that the queue is full and it is dropping events.

According to the man page for audisp-remote.conf (as found at
linux.die.net), the parameter "mode" can be set to "immediate" or
"forward". "forward" means that events are buffered in a queue.

I found that "mode" was set to "immediate", and the queue did not exist.

But when I try to set the value as "forward" and restart auditd,
audisp-remote complains that "Option forward not found". And the queue
still gets full.

Last October, Steve was writing about how big the queue might be on this
very site.

Can someone explain what is going on?

Thanks - Michael
----------------


--
Linux-audit mailing list
Linux-audit redhat com
https://www.redhat.com/mailman/listinfo/linux-audit



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]