[Linux-cluster] fence_sanbox2 configuration example?

[Dan B. Phung]

Can somebody who's using the fence_sanbox2 agent let me take a peek at 
their config?  


here's what I have so far for fencedevices:
   <fencedevices>
   <fencedevice name="human" agent="fence_manual"/>
      <fencedevice name="san" agent="fence_sanbox2"
         ipaddr="fsm.cs.columbia.edu" login="foo" passwd="bar"/>
   </fencedevices>

is the port indicated in the manpage the WWN for the host bus adaptor?

       -n port
              The port number to disable on the switch.


here's what I think I should have in each clusternode entry:

          <clusternode name="blade01" nodeid="1" votes="1">
          <multicast addr="224.0.0.1" interface="eth0"/>
             <fence>
               <method name="fibre">
                 <device name="san" port="2100000d55d32ced"/>
               </method>

               <method name="single">
                 <device name="human" port="128.59.18.1"/>
               </method>
             </fence>
          </clusternode>


and to test this, I was going to suddenly turn off networking
for the blade and see how the rest of the cluster reacts.  

-dan

--