[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: [Linux-cluster] HP msa20 and rhcs?



Since msa20 allows multi-initiator connections than I think it works with
dl380 since it has an external scsi port. Also I have heard that msa20 can
have an internal raid controller so ACU can configure it.


By the way I have doubts to use shared scsi in RHCS. Does anyone use it (I
am sure there are) and those who use it recommend it for a cheap but
RELIABLE cluster storage with RHCS?



> The MSA20 is only a disk shelf. You'd need to have it conneted to a raid
> controller
> which is built into the DL360 and above, or simply access the individual
> drives
> themselves. It does allow multi-initiator connections, but I think it's
> more
> along
> the lines of having multiple paths to an MSA500 which is a two node
> non-fibre
> SAN
> if it can even be considered a SAN since no fibre is involved. It's not
> more
> than
> a high end external storage device.
>
>
>
> Corey
>
> -----Original Message-----
> From: linux-cluster-bounces redhat com
> [mailto:linux-cluster-bounces redhat com] On Behalf Of Lon Hohberger
> Sent: Monday, May 08, 2006 10:11 AM
> To: omer faruk net; linux clustering
> Subject: Re: [Linux-cluster] HP msa20 and rhcs?
>
> On Mon, 2006-05-01 at 22:11 +0300, Omer Faruk Sen wrote:
>> Hi,
>>
>> I need a cheap shared storage and wanted to know if anyone in this
>> list used HP MSA20  (shared SCSI) on rhcs? I want to setup a 2 node
>> cluster with shared storage and cheapest HP shared storage seems to be
> MSA20..
>
> I've never used one; maybe someone else has.
>
> General rules of thumb when using SCSI shared storage:
>
> * If it requires a specific controller to make the RAID work, it probably
> is
> not a good bet, regardless of what the marketing literature would have you
> believe.
>
> * If it works with a plain-jane SCSI (ex- an Adaptec 2940U2W) card and
> still
> has some way of accessing the array management tools (ex: a serial
> port) for configuring/presenting the LUNs, it should generally "just
> work".
>
> There are undoubtedly exceptions to these rules.  I'm not at all familiar
> with the MSA20.
>
> I do, however, have a MSA500 which has been working fine.  The MSA500
> needs
> CCISS controllers to talk to the on-board MSA controller and configure the
> LUNs during bootup.  After that, the CCISS controllers act as "dumb" SCSI
> cards when talking to the MSA500, or so it seems.  It's been working fine
> in
> a 2-node failover cluster for a couple of years, but I have not tried it
> with
> GFS.
>
> Whether that means the MSA20 will work... I do not know.  It might ;)
>
> -- Lon
>
> --
> Linux-cluster mailing list
> Linux-cluster redhat com
> https://www.redhat.com/mailman/listinfo/linux-cluster
>


-- 
Omer Faruk Sen
http://www.faruk.net


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]