[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: [Linux-cluster] General FC Question



> You don't say which FC cards you are using but if it's qlogic, then the
> driver can be set to combine the devices. Basically whats happened is that 
>your machine is picking up the alternate path to the device, which is a 
>perfectly valid thing to do, it's just not what you need at this point. It 
>may be as simple as your

The cards are all Qlogic, the switch is going to be an ED-5000 next week, the 
storage is mostly Xyratex chassis.
 
>secondary controller actually has the lun you are trying to access. To work
>around yo might just be able to reset the seconday controller and force the 
>primary to take over the LUN. This happens quite a bit depending on your 
>setup. 

I do have options on the Xyratex to combine the two controllers into one 
number but that's the loop ID. Not sure I've seen anything for LUN control 
yet. 

> Even without failover, the latest Qlogic drivers will make both paths active
> so that you never end up with a dead path upon boot up.

Path's seem fine, I mean, the storage does show up. It's just that my initial 
device has moved to another /dev/sdx number. In another message, am I to 
understand that once the physical device is set up and running as a GFS 
volume, that LVM2 will always see it no matter if the /dev number changes?

I'll also have to look into your suggestions. 

Thank you very much.

Mike




[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]