[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: [Linux-cluster] RHCS with two Network card



Thanks Moralejo

But im asking about make the heartbeat and the communication to used on both interface (Ethernet bond) so the two interface will be as failover for each other

 

From: linux-cluster-bounces redhat com [mailto:linux-cluster-bounces redhat com] On Behalf Of Moralejo, Alfredo
Sent: Wednesday, May 27, 2009 11:29 PM
To: linux clustering
Subject: RE: [Linux-cluster] RHCS with two Network card

 

You can take a look to:

 

http://kbase.redhat.com/faq/docs/DOC-5975

 

I guess it can help you.

 

Related to this. As far as I know conga can not be used from a system out of the cluster to configure clusters when private networks are used for inter-cluster communication, is that right?

 

 

 

 


From: linux-cluster-bounces redhat com [mailto:linux-cluster-bounces redhat com] On Behalf Of anasnajj
Sent: Wednesday, May 27, 2009 9:42 PM
To: linux-cluster redhat com
Subject: [Linux-cluster] RHCS with two Network card

 

Hi all

I have 5 cluster node and each node have two network card eth0 ,eth1

My cluster services  have the IP Virtual ranges 10.0.10.100-103

And Eth0 have IP  range  10.10.10.10 -13..

I need to setup up the second interface Eth1 to used as heartbeat communication and used as failover for Eth0  if the eth0 have cable failure or down , so how I can implement such scenario???

 

 

 

No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.339 / Virus Database: 270.12.39/2133 - Release Date: 05/25/09 08:16:00


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]