[Linux-cluster] consistent quorum disk on cluster nodes

[James Marcinek]

ok,

So I can specify it by the label when I issued the mkqdisk -c /dev/sdx -l quorum command (where x is device)?

Thanks,

James
----- Original Message -----
From: "Marc - A. Dahlhaus [ Administration | Westermann GmbH ]" <mad at wol.de>
To: "linux clustering" <linux-cluster at redhat.com>
Sent: Thursday, September 17, 2009 12:46:04 PM GMT -05:00 US/Canada Eastern
Subject: Re: [Linux-cluster] consistent quorum disk on cluster nodes

Am Donnerstag, den 17.09.2009, 12:30 -0400 schrieb James Marcinek:
> Hello all,
> 
> Can anyone point me in the right direction to some examples of defining udev rules for quorum disks (or disks in general). I'm reading in the docs that the quorum disk needs to be the same on all nodes. I have 2 node clusters, which I've allocated a shared 100MB lun that I've created the quorum disk (mkqdisk command); however the devices are not showing up as the same device (eg /dev/sdc on one node and /dev/sdb on the other ). 
> 
> If the quorum disk could be managed by lvm that would likely make life easier but I'm not sure that would work or is supported, but I think that would be easier than having to create a udev rule for it...
> 
> Thanks,
> 
> james

You should try to use the LABEL of the qdisk to select it.

man qdiskd

Marc

--
Linux-cluster mailing list
Linux-cluster at redhat.com
https://www.redhat.com/mailman/listinfo/linux-cluster