[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [Linux-cluster] pull plug on node, service never relocates



What is the state of service that was running in the node after pulling the power cables? stopped, failed?

Set rgmanager in verbose mode with <rm log_level="7" log_facility="local4">

Regards

Alfredo


On 05/19/2010 07:08 PM, Dusty wrote:
In the interest of trouble-shooting I've taken all the failover domains out of the configuration.

This resulted in no change:

Service on a failed node does not relocate until the failed node reboots.

To reiterate: Similar cluster configuration on similar hardware worked perfectly on RHEL5U3.
-- Linux-cluster mailing list Linux-cluster redhat com https://www.redhat.com/mailman/listinfo/linux-cluster


--

Alfredo Moralejo
Red Hat - Senior consultant

Office: +34 914148838
Cell: +34 607909535
Email: alfredo moralejo redhat com

Dirección Comercial: C/Jose Bardasano Baos, 9, Edif. Gorbea 3, planta 3ºD, 28016 Madrid, Spain
Dirección Registrada: Red Hat S.L., C/ Velazquez 63, Madrid 28001, Spain
Inscrita en el Reg. Mercantil de Madrid – C.I.F. B82657941

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]