[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [Linux-cluster] pull plug on node, service never relocates



Have the cluster properly relocating services immediately upon simulated node failure now.

Removed this from the failover domain configs: nofailback="1"

Somehow this option, even after rebooting the entire cluster, was keeping services from relocating until a failed node rejoined the domain - unless there were two spare nodes available.

On Wed, May 19, 2010 at 2:42 PM, Alfredo Moralejo <amoralej redhat com> wrote:
What is the state of service that was running in the node after pulling the power cables? stopped, failed?

Set rgmanager in verbose mode with <rm log_level="7" log_facility="local4">

Regards

Alfredo



On 05/19/2010 07:08 PM, Dusty wrote:
In the interest of trouble-shooting I've taken all the failover domains out of the configuration.

This resulted in no change:

Service on a failed node does not relocate until the failed node reboots.

To reiterate: Similar cluster configuration on similar hardware worked perfectly on RHEL5U3.
-- Linux-cluster mailing list


--

Alfredo Moralejo
Red Hat - Senior consultant

Office: +34 914148838
Cell: +34 607909535
Email: alfredo moralejo redhat com

Dirección Comercial: C/Jose Bardasano Baos, 9, Edif. Gorbea 3, planta 3ºD, 28016 Madrid, Spain
Dirección Registrada: Red Hat S.L., C/ Velazquez 63, Madrid 28001, Spain
Inscrita en el Reg. Mercantil de Madrid – C.I.F. B82657941

--
Linux-cluster mailing list
Linux-cluster redhat com
https://www.redhat.com/mailman/listinfo/linux-cluster


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]