[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [Linux-cluster] Updating cluster.conf file under RHEL6



What about people that build their cluster 'by hand' or using the GUI tool?
(AKA nor Luci)
Do they still need to run Ricci?

Isn't that what ccsd was for?


Regards,

Kit

-----Original Message-----
From: linux-cluster-bounces redhat com
[mailto:linux-cluster-bounces redhat com] On Behalf Of Fabio M. Di Nitto
Sent: zondag 28 november 2010 10:57
To: linux-cluster redhat com
Subject: Re: [Linux-cluster] Updating cluster.conf file under RHEL6

On 11/27/2010 10:00 PM, carlopmart wrote:
> Hi all,
> 
>  I have downloaded a trial RHEL6 DVD to test new cluster suite under 
> this platform (cman-3.0.12-23.el6_0.4.x86_64). After install one node, 
> I have migrated some data from my production's cluster that consists 
> on two RHEL 5.5 nodes.
> 
>  All works ok (moving cluster.conf file, data, etc), except when I try 
> to modify and propagate new cluster.conf file. In RedHat's 
> documentation
> says: "Run the cman_tool version -r command to propagate the 
> configuration to the rest of the cluster nodes.". This procedure works 
> if all nodes are up, but if I try to do this with only one up returns 
> this error:
> 
> Error: Unable to initialize the crypto subsystem.
> cman_tool: ccs_sync failed.
> If you have distributed the config file yourself, try re-running with 
> -S

Do you have ricci running on the nodes? If not, you need to enable it.

I am fairly confident the documentation mentions that too.

cman_tool version -r -S would be the correct command IF the configuration
has been synced around manually (see the "propagate the configuration via
scp" section of the documentation).

Fabio

--
Linux-cluster mailing list
Linux-cluster redhat com
https://www.redhat.com/mailman/listinfo/linux-cluster


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]