On Wed, Apr 27, 2011 at 1:59 PM, Parvez Shaikh <parvez h shaikh gmail com>
I am using RHCS on IBM bladecenter with blade center fencing. I plugged out a blade from blade center chassis slot and was hoping that failover to occur. However when I did so, I get following message -
fenced: agent "fence_bladecenter" reports: Failed: Unable to obtain
correct plug status or plug is not available
fenced: fence "blade1" failed
Is this supported that if I plug out blade from its slot, then failover occur without manual intervention? If so, which fencing must I use?
Linux-cluster mailing list
Linux-cluster redhat com