[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[linux-lvm]VG Recovery off multiple PV's



I saw your message in January but I have been working on the "mysteries of LVM on-disk layout". Here is what I "think" I've found.
1) Even if your lvm is screwed up, your ext2/3 data is probably still there since that volume wasn't the one with physical problems.
2) If you want to "backup" for safety's sake your ext2 data then you need to do a pvdata for each of your partitions. The developers have a better handle on this, maybe one day they will post to your problem.
The Ext2 filesystem is placed on a hard disk starting at 1024 bytes in from the beginning of the partition. This is probably for MBR areas (which are usually 512 bytes I believe).
There is a 56 byte data area (mine always start with 0x00)
There is the magic number for the filesystem type 53EF (this is byte reversed order of 0xEF53. Magic numbers found in /usr/share/misc/magic)
The there is your ext2 partition metadata and data (I don't care of the layout and neither do you, only the size).
Question is where is this on the partition? And the answer is, this is roughly dynamically assigned space based on the size of your physical volume (I am guessing, you have to look at the lvm code). I used dd to find out using hexedit what is going on here :
I will use your first partition /dev/hdg1 to work on all examples.
dd if=/dev/hdg1 of=(any filename on a partition with space to hold it lets call it hdg1.e2fs for example) ibs=512 obs=1M count=(supposed to be ibs * this count=total bytes but I didn't have the space for it on mine so I can't be sure)
Your data is saved. Now the hard part is to either mount it in the loopback mount, note: the directory name can be anything.
mkdir /mnt/widget mount -t ext3 -o ro,errors=continue,loop (full path)/hdg1 /mnt/widget
Now mine says the standard error of bad superblock, etc... And this is as far as I got. Maybe you won't have my problems.
Also, my theory is that if you have a comparable disk and lets say it is hdf then you should be able to dd directly to that disk and it should mount ok (my theory only but I am going to try it when my drive arrives). the command would be :
dd if=/dev/hdg1 of=/dev/hdf ibs=512 obs=1M count=60G
About 45mins later roughly it should be done. There is NO status info in dd saying nn% complete or anything like that, just let it run.


After all data is accounted for and backed up then you can restart the LVM process.
I hope this helps a little, sorry I haven't the experience (yet) to tell you how to finish the recovery.


I want to say though, that as you start your LVM init process for the disks that the lvm dir should be backed up at each step then reboot to make sure everything is ok. Short of this and you will get yourself into my situation, where there is data and preferences that have accummulated over time that I never thought to backup, I copied the data to the lvm, everything looked ok, booted ok, then BLAM primary boot disk dies and takes all of the LVM data with it, with nearly no chance of recovery. C'est la vie!

Good luck. Happy hunting.
-T-






[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]