[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

[linux-lvm] Is cLVM necessary when accessing different logical volumes on a shared iSCSI target?



Hi list!
I have an iSCSI server (using LIO) which provides one LUN. Two client
machines each connect this same LUN. From the client's perspective, let's
say it shows up as device /dev/sda. I have then in one client created a
partition /dev/sda1 with type 8e (LVM). The partition immediately shows up
in the other client.
After that, I have created a physical LVM volume (pvcreate /dev/sda1) and a
volume group (vgcreate shared /dev/sda1). Note that I have not enabled
cluster mode for this volume group. Again, both the physical volume and the
volume group are immediately visible to the other client.
When I create in one client a logical volume in this volume group, it is
visible to the other client, but it is unavailable. This works in both
directions, i.e. I can create a logical volume in one client or the other,
and it is always visible, but unavailable to the other client.
So far, everything seems to work fine. Now my question is: Is this setup
sufficient or do I need cLVM? I have tried to install cLVM, but had some
problems, because I do not have (and probably do not need?) a cluster
manager.
Could anybody explain when cLVM is needed in general and if it is necessary
for me?

Kind regards,
Christian

------------------------------------------------------------
Deriva GmbH Financial IT and Consulting
Christian Schröder
Geschäftsführer
Hans-Böckler-Straße 2 | D-37079 Göttingen
Tel: +49 (0)551 489 500-42
Fax: +49 (0)551 489 500-91
http://www.deriva.de

Amtsgericht Göttingen | HRB 3240
Geschäftsführer: Dirk Baule, Christian Schröder





[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]