[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [Ovirt-devel] Re: NIC bonding and failover...



On Thu, Sep 04, 2008 at 08:43:24PM +0200, Chris Lalancette wrote:
> Konrad Rzeszutek wrote:
> > On Thu, Sep 04, 2008 at 07:46:13PM +0200, Chris Lalancette wrote:
> >> Darryl L. Pierce wrote:
> >>> I'm in the not-an-expert camp as well. But, whe nyou say "expose which
> >>> method" what do you mean there? From my understanding, the way you would
> >>> configure bonding is to load the bonding module and specify which mode to use
> >>> there via "modprobe bonding mode=[#] miimon=[interval]". Is there some
> > .. snip ..
> >> modprobe bond mode=# arp_ping=ip arp_interval=xxx
> > 
> > You still need the steps to enslave a NIC to the bond, setting which type it is, etc.
> 
> Right, this will all be done at boot time, based on what the admin configures.

<scratches his head>

What is the delivery mechanism? Is it going to be similar to the way the krb5.tab is
being found+pulled. And then the config file would be parsed and set the right
things? Or would this be done via libvirt (http://wiki.libvirt.org/page/TodoNICBonding)

.. snip ..

> > I would be curious to know what you guys think is the right way to solve these problems?
> 
> Don't get me wrong; there are a lot of issues around bonding.  But I guess we'll
> start small and build from there :).

Yes definitely. I am trying to grok the libvirt+ovirt way and figured that asking
questions like these would crystallize a good understanding in my mind.

> 
> Chris Lalancette


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]