Determining the interface kickstart will used during the buildwhenthere a more than one

[Tobias Speckbacher]

Thanks !

That makes a lot of sense now that I rethink it, seeing that ks.cfg may
or may not be available at the time the network is being brought up
(depending on where you store it).

-T

-----Original Message-----
From: redhat-list-bounces at redhat.com
[mailto:redhat-list-bounces at redhat.com] On Behalf Of T Jackson
Sent: Wednesday, April 07, 2004 12:37 PM
To: General Red Hat Linux discussion list
Subject: RE: Determining the interface kickstart will used during the
buildwhenthere a more than one 

Tobias, 
If you want to boot from a specific device all you
have to do is add "ksdevice=eth0" to the append
section of the pxelinux.cfg file.  

The problem is if you have a machine with multiple
interfaces and you want to build from aspecific one. 
How do you know that interface will be eth0, eth1 or
eth2.  How can you determine which nic will get which
device name?

--- Tobias Speckbacher <tobias at quova.com> wrote:
> Just from recent experience, even when explicitly
> specifying:
> 
> network --bootproto=dhcp --device=eth0
> 
> I get prompted to select the interface to use.
> So far I haven't had time to research how to work
> around this.
> 
> -T
> 
> -----Original Message-----
> From: redhat-list-bounces at redhat.com
> [mailto:redhat-list-bounces at redhat.com] On Behalf Of
> T Jackson
> Sent: Wednesday, April 07, 2004 10:10 AM
> To: redhat-list at redhat.com
> Subject: Determining the interface kickstart will
> used during the build
> whenthere a more than one 
> 
> Does anyone know how to determine which network card
> red hat installer will assign eth1, eth2, etc to
> when
> performing a kickstart installation?  
> Example 
> I have a machine with 3 network cards and I want to
> install Red Hat over the network using kickstart so
> I
> do not have to enter any information.   
> 
> Now I am able to perform the installation using
> pxelinux / dhcp / nfs /ftp when I only have one
> network interface in the machine but when I try to
> build a machine with multiple network interfaces I
> am
> either prompted to select a interface (which is a
> big
> problem when all the interfaces are the same brand
> /model) or the installation falls through to the
> menu
> for.
> 
> Any ideals how I can determine the interface so I
> know
> what parameter to feed the install through the
> “ksdevice” option?
> 
> 
> -- 
> redhat-list mailing list
> unsubscribe
>
mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
> 
> 
> -- 
> redhat-list mailing list
> unsubscribe
>
mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list


-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list