Kudzu cannot detect 2nd network card

[Oluwagbega Shobowale]

Please check the irq on both cards they should not be the same. Change
the irq both cards can not be using the same irq on the same machine...


-----Original Message-----
From: redhat-list-bounces at redhat.com
[mailto:redhat-list-bounces at redhat.com] On Behalf Of Ong Ying Ying
Sent: Thursday, March 30, 2006 7:34 AM
To: General Red Hat Linux discussion list
Subject: Re: Kudzu cannot detect 2nd network card


Greg Golin wrote:
> What card is this? Who is the vendor and what is the model? I suggest 
> you check whether the vendor provides newer drivers -- Seawolf is 
> quite old. You could also try and boot with a live cd, or to a rescue 
> mode of a later distribution install, and see if both cards get 
> initialized.
> 
isapnp: Card 'Relia RE-2019 plug & Play Ethernet card'

NE*000 ethercard probe at 0x240: 00 c0 0c 50 ...
eth0: NE2000 ...  using IRQ 10

Both card are the same type of card. Both are ok as they can 
be used on one same isa port. The other isa port cannot 
detect both of them so I guess it is spoilt. Do isa ports 
need drivers or controllers?


There's no place to enable second NIC nor isa port in BIOS. 
PCI, Serial, Parallel and IDE have in BIOS.


> G
> 
> On 3/29/06, Oluwagbega Shobowale <gshobowale at nextworksltd.com> wrote:
> 
>>I think you should check if the network card is functional if it is 
>>check that the slot if working also. Then do your test again
>>
>>-----Original Message-----
>>From: redhat-list-bounces at redhat.com 
>>[mailto:redhat-list-bounces at redhat.com] On Behalf Of Ong Ying Ying
>>Sent: Wednesday, March 29, 2006 4:16 PM
>>To: redhat-list at redhat.com
>>Subject: Kudzu cannot detect 2nd network card
>>
>>
>>I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2.
>>
>>I have 2 network cards in my computer but kudzu detected 1 card only. 
>>Why? ifconfig showed eth0 and lo only.
>>
>>Then, I setup 2 interface in Network Configurator in X-Win and reboot.

>>Kudzu still didn't detect and 'modprobe: Can't locate module eth1' at 
>>Bringing up eth1. eth1 cannot be activated on startup but it can be 
>>activate in X but cannot save.
>>
>>So how do I configure the other network card? Both the network cards 
>>are the same. Network Configuration in Text Mode Setup can enter 1 IP 
>>only. dmesg shows 1 network card only.
>>
>>Thanks in advance.
>>
>>
>>--
>>redhat-list mailing list
>>unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
>>https://www.redhat.com/mailman/listinfo/redhat-list
>>
>>--
>>redhat-list mailing list
>>unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
>>https://www.redhat.com/mailman/listinfo/redhat-list
>>



-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list