Problem with bonded (teaming) NIC's on RHEL 4.0

[SIG - Pédagogie]

Anne Moore a écrit :
> Hi all RH experts, 
>  
> I have bonded my two GIGI speed nic's on my red hat enterprise 4.0 server.
> They were (before the bonding) running at 1 GIGI speed. However, now that
> they are bonded together, it runs at 10Mbits. I used this procedure:
> http://www.cyberciti.biz/tips/linux-bond-or-team-multiple-network-interfaces
> -nic-into-single-interface.html
>  
> I get the 10Mbits result when running the command mii-tool bond0. 
>  
> Any ideas what the problem here is? Or why I'm only getting 10Mbits now? 
>  
> Thank you for your assistance.

Hi,

I have the same thing :

# mii-tool -v bond0
bond0: 10 Mbit, half duplex, link ok
   product info: vendor 00:01:00, model 0 rev 4
   basic mode:   10 Mbit, half duplex
   basic status: link ok
   capabilities:
   advertising:

It's "mii-tool" getting confused. What matters are the bonded interface 
speed, not the speed of bond0 displayed by mii-tool.

Look at the speed of your physical interface and that will be the speed 
of bond0.

# ethtool eth0
Settings for eth0:
         Supported ports: [ FIBRE ]
         Supported link modes:   1000baseT/Full
         Supports auto-negotiation: Yes
         Advertised link modes:  1000baseT/Full
         Advertised auto-negotiation: Yes
         Speed: 1000Mb/s
         Duplex: Full
         Port: FIBRE
         PHYAD: 2
         Transceiver: internal
         Auto-negotiation: on
         Supports Wake-on: g
         Wake-on: d
         Link detected: yes


-- 
Nicolas

-- 
Ce message a ete verifie par MailScanner
pour des virus ou des polluriels et rien de
suspect n'a ete trouve.