[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: scsi_id



Thanks to all. I will try to use another devnode entry. Let me see. If
i'm successful i will post it.

On Tue, Sep 8, 2009 at 10:56 PM, Thomas Fess <dfezz1 yahoo com> wrote:
> If that is the case, then you may need to use an HP controller command to retrieve the WWID or install HP controller software, somethin similar to powerpath or ECC for EMC
>
>
>
>
> ________________________________
> From: Edson Marquezani Filho <edsonmarquezani gmail com>
> To: General Red Hat Linux discussion list <redhat-list redhat com>
> Sent: Tuesday, September 8, 2009 1:42:51 PM
> Subject: Re: scsi_id
>
> On Tue, Sep 8, 2009 at 13:40, <m roth 5-cent us> wrote:
>>> I am not sure which scsi device you are searching for , but you should see
>>> an sda, sdb type number.  So when querying for the wwid of the interal
>>> disk, use that descriptor.
>>> such as:
>>>
>>> scsi_id -g -u -s /block/sda (instead of /dev/cciss/c0d0)
>> <snip>
>> What are you running this on - that /dev/cciss/c0d0 sure looks like
>> Solaris to me, not Linux.
>>
>>        mark
>>
>
> Singles disks or disk arrays with HP Controllers (like Smart Array
> e200i) appears like this on Linux. At least with all HP Proliants I
> have seen so far.
>
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request redhat com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>
>
>
>
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request redhat com?subjectunsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]