Network : Bridge over bonding

[Jim Bourne]

>> You probably want to bond eth0 and eth1 into a mode 1 bond, which is
>> active/standby based on link status. You then want to make the bond0
>> interface a member of bridge0.
>>
>> From original mail:
> BONDING_OPTS="mode=1 primary=eth0 miimon=100"
>

Just curious, why would one opt for mode 1 over 802.3ad?  If your switch
hardware allows link aggregation across chassis I would think that would be
the best way to maximize throughput and availability.

Regards
etc

-- 
James Bourne                  | Email:            jbourne at hardrock.org
UNIX Systems Administration   | WWW:           http://www.hardrock.org
Custom UNIX Programming       | Linux:  The choice of a GNU generation
----------------------------------------------------------------------
"All you need's  an occasional kick in  the philosophy." Frank Herbert
Need an inexpensive domain alternative?  http://fastforwarddomains.com