[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Network : Bridge over bonding



> > > You probably want to bond eth0 and eth1 into a mode 1 bond, which is
> > > active/standby based on link status. You then want to make the bond0
> > > interface a member of bridge0.
> > >
> > > From original mail:
> > BONDING_OPTS="mode=1 primary=eth0 miimon=100"
> >
>
> Just curious, why would one opt for mode 1 over 802.3ad?  If your switch
> hardware allows link aggregation across chassis I would think that would be
> the best way to maximize throughput and availability.
>
> Regards
> etc

If you are on a single chassis or have OTV support (a logically unified chassis),
by all means, do 802.3ad :)

-- 
Matthew Galgoci
Network Operations
Red Hat, Inc
919.754.3700 x44155
------------------------------
"It's not whether you get knocked down, it's whether you get up." - Vince Lombardi


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]