[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

process to changing default of CONFIG_SERIAL_8250_NR_UARTS=4 to 24

What then is the process to request that a change be made in the default configuration
to have CONFIG_SERIAL_NR_UARTS=24 and not the present default of 4.




I would suggest a configuration issue, not a bug.  The kernel config
for 2.6.9 - 681 shows:


The default configuration between Red Hat 9 and Fedora Core 3 at the
kernel level has changed.  Your configuration is a bit different than
what is normally used in other words.

On Fri, 31 Dec 2004 20:15:09 -0500, Jerry Geis <geisj pagestation com> wrote:


I just installed FC3 from Redhat 9. I have a quatech multiport card with
8 ports.
Under redhat 9 there was no problem card was detect and I had ports 4 - 11.
Under FC3 the card is detected but the order of the ports is ALL messed up.
I am attempt to change the CONFIG_SERIAL_8250_NR_UARTS to 24.
I am recompiling the kernel now. I chose 24 to support 3 - 8 port serial

Is this a configuration bug or oversite or what is going on that my 8
port multiport
card is not supported that worked fine under redhat 9.



-- fedora-devel-list mailing list fedora-devel-list redhat com http://www.redhat.com/mailman/listinfo/fedora-devel-list
-- This message was scanned for spam and viruses by BitDefender. For more information please visit http://linux.bitdefender.com/ ******************************* This message has been blocked because it scored over the maximum spam threshold. The reason your message was denied was because of the following: Yes, score=5.0 required=5.0 tests=USERNAME_IN_SUBJECT autolearn=no version=3.0.0 Your message contained an instance of the previously mentioned tests (see test= above) If you did not send the original message then please ignore this e-mail. Sat Jan 1 09:18:02 EST 2005

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]