[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: router using FC4



LC wrote:
Hi,

I am trying to make a router using a FC4. I have 2 NICs in the machine. Install FC4 using minimium. Eth0 is set to DHCP, connected to an ethernet modem and ETH1 has IP 192.168.1.1, netmask 255.255.255.0 connected to a switch. Installation was a success and rebooted the box. Clients machines are unable to ping 192.168.1.1. But when i unplug the modem and reboot, clients are ablt to ping 192.168.1.1. I realised if the box booted up both ETH0 and ETH1, clients are able to ping 192.168.1.1. But if i ifdown ETH0 and ifup ETH0, clients are able to get reply from 192.168.1.1.

Can someone tell me what should I do?

Best regards

/etc/sysctl.conf:

# Controls IP packet forwarding
net.ipv4.ip_forward = 0
                      ^

--
 Bob Marcan, Consultant                mailto:bob marcan snt si
 S&T Hermes Plus d.d.                  tel:   +386 (1) 5895-300
 Leskoskova cesta 6                    fax:   +386 (1) 5895-202
 1000 Ljubljana, Slovenia              url:   http://www.snt.si


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]