NVMe vs M.2: What's the difference? 

If you've been around computers, and technology in general, for any amount of time, you're probably aware of the huge advancements in storage that have been made over the last few decades. I'm a 90's kid, so I only have a limited scope of experience with some of the older storage mediums. I did get the chance to work with a few companies at my last job that stored off-site data on massive tape drives but the read/write functions to those enormous sloths were less than pleasant.

To my knowledge, most of our enterprise storage is probably still done via disk drives (spinning platter drives), commonly referred to as HDDs (hard disk drives). However, solid-state drives (SSDs) have replaced HDDs and are what most people currently use in their personal computers. Previously, SSDs were more expensive. However, lately, those prices have dropped to affordable levels.

[ You might also like: Converting to solid-state disks (SSDs) on the desktop ]

As storage mediums evolve, so do storage interfaces. Traditionally, HDDs and SSDs used SATA interfaces to communicate with their motherboards (unless you work on ancient gear such as SCSI or PATA. Shoutout to the US Navy).

SATA interfaces need two things to operate correctly:

1. SATA power from the power supply to the drive
2. SATA data from the drive to the motherboard controller

These are delivered through two separate cables (not ideal) or through a single integrated cable. Either way, the cables used have fragile connectors, and any cable introduces some form of latency. Maybe it's time for some evolution.

NVMe has entered the chat

Non-Volatile Memory Express (NVMe) was developed as a new standard specification for storage drives (and other components) to be connected directly to the PCIe interface. Using this bus allows the SSD to communicate directly with the CPU instead of going through the motherboard as SATA previously required, increasing read/write speeds and decreasing program load times.

So what is M.2?

To answer this question, we need to talk about form factors. Many commercial HDDs are sold in 3.5" and 2.5" form factors. Up until recently, most SSDs were sold in 2.5" form factors. Most all of these drives were SATA drives, requiring data and power cables. M.2 is the newest form factor of SSD to hit the market, with an incredibly small footprint thanks to the NVMe interface.

An M.2 slot is 22mm wide and can vary in length depending on your motherboard slots. The measurements can range from 16 - 110 mm (most drives are 80mm). Be sure to pick a drive that fits the space available on your device! The beauty of this form factor is that there are absolutely no cables involved. The drives just slot into the M.2 slot on the motherboard and are connected via NVMe to the CPU.

[ A free guide from Red Hat: 5 steps to automate your business. ] 

What to shop for

The quick answer to the NVMe versus M.2 question is that there is no versus at all. NVMe is the interface, and M.2 is the latest form factor for SSDs. Combine the two, and you have a lightning-fast drive with almost no visible footprint, and it is super-easy to install. Win. Win. Win.

When shopping for a drive, make sure that you know the interface and the form factor, on top of the capacity and read/write speeds. Keep this information in mind during your next storage expansion, and you will make a well-informed purchase.

Also, if you are planning on building a new system, be sure to check out my previous article, "Sysadmin hardware: Considerations for planning a PC build."